GMRS
FCC Warning Statement
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Compliance with RF Exposure Standards
WARNING: MODIFICATION OF THIS DEVICE TO RECEIVE CELLULAR
RADIOTELEPHONE SERVICE SIGNALS IS PROHIBITED UNDER FCC RULES AND
FEDERAL LAW.
FCC Regulatory Conformance
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference including received interference that may
cause undesired operation.
The grantee is not responsible for any changes or modifications not expressly
approved by the party responsible for compliance. Such modifications could void the
user’s authority to operate the equipment.
Replacement of any transmitter component (crystal, semiconductor, etc) not
authorized by the FCC equipment authorization for this radio could violate FCC rules.
This radio complies with IEEE and ICNIRP exposure limits for general population/uncontrolled
RF exposure environment at operating duty cycle of up to 50% and is authorized by the FCC
for general population/uncontrolled use only. An appropriate warning label is affixed to all units.
In order to comply with RF exposure requirements, a minimum distance of 25mm must be
maintained when held-to-face, and Back Touch operations are restricted to the approved original
accessories (belt clip),a minimum distance of 0 cm. Do not use this device when antenna shows
obvious damages.
