Remote Control for Laser Level
OPERATING INSTRUCTIONS
Initial Pairing with the Remote Control
When using your remote control for the first time, a one-time pairing
process is needed:
1. Turn your Maestro laser level on.
2. Within 3 seconds, press the V2 button on your remote control.
3. A successful pairing is indicated by a beep on your Maestro level.
OPERATING INSTRUCTIONS
Select the desired line configuration by pressing the respective
buttons on the keypad:
a. Horizontal line button operates in the following cycle:
Top Horizontal active (default) → No lines → Bottom
horizontal.
b. Vertical lines buttons operates as ON\OFF buttons for V1 and V2.
C.Short press on ECO/ button (2.d) to activate ECO mode& Flash mode
Federal Communications Commission (FCC) Statement.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause
undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide Reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
•Reorient or relocate the receiving antenna.
•Increase the separation between the equipment and receiver.
•Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
•Consult the dealer or an experienced radio/TV technician for help.
Warning: Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
Note: The manufacturer is not responsible for any radio or TV interference caused by
unauthorized modifications to this equipment. Such modifications could void the user’s authority
to operate the equipment.
RF exposure statement:
This device complies with FCC RF radiation exposure limits set forth for an uncontrolled
environment. The device is installed and operated without restriction.
