Operation Instructions for Control Panel
1.Control Panel as shown below
2. Battery Usage Requirements
Batterytype:UsetwoAAAalkalinebatteries.Donotmixoldandnewbatteries
or use different types of batteries together.
Installation:Insertthebatteriescorrectlyaccordingtothepolaritymarkings
(+/-) in the battery compartment. If the remote controller will not be used
foralongperiod,removethebatteriestopreventleakagethatmaydamagethe
remote controller.
Low battery indication: When the remote control range becomes noticeably
shorter or the response is sluggish, replace the batteries promptly.
*Damage caused by battery leakage is not covered under warranty.
*This remote controller features wireless two-way communication, allowing
real-time monitoring of the device's operating status from a distance. It
supports one-to-one operation only; simultaneous use of multiple remote
controllers may cause data errors.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The device can be
used in portable exposure condition without restriction
