Remote Control Instructions
ON
Power On (Defaults to A1 Auto Mode)
OFF
Turn off the lights
DMX
DMX mode
AUTO
Auto Mode, cycles function with each
press.
speed+
Increase automatic change rate
speed-
Decrease automatic change rate
voice
Voice control mode
mic+
Increased voice control sensitivity
mic-
Reduced voice control sensitivity
1
Red beam light on
2
Green beam light on
3
Blue beam light on
4
White beam light on
5
Red&Green LS light on
6
White light strobe effect
7
A1 Self- driving mode
8
A2 self-driving mode
9
S1 Voice Control Mode
0
S2 voice control mode
*#
No function
INGESTION HAZARD:
This product contains a button or coin cell battery.
DEATH or serious injury can occur if ingested.
A swallowed button or coin battery can cause Internal.
Chemical Burns in as little as 2 hour.
FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.
NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the followingmeasures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
FCC Radiation Exposure Statement：
The equipment complies with FCC Radiation exposure limit set forth for uncontrolled environment. The device shall be
operated and installed without restrcition.
