Quick Use Guide
Wireless Headphone
Power On
Long press 3 seconds the multi-function button. a
tone will be heard. The LED indicator will turn Blue
lights.
Bluetooth Pairing
The LED indicator will flash Red and Blue lights
indicate that enter bluetooth pairing mode.
Choose pairing name "BSHP1270" to pair with your
device. Once successfully, a tone will be heard
indicating that the headphone paired. After paired
successfully, BLUE lights will slowly flash every 5
seconds.
(The headphone will automatically reconnect to
the device they were most recently paired to, so
long as that device is within connection range(33ft)
and Bluetooth is enabled)
"+"button：short press to increase the volume.
Long press to skip to next track.
"-"button: short press to decrease the volume.
Long press to skip to previous track.
"Multi-function" button:
a. Short press to play/pause the music.
b. When a incoming call, short press to answer,
short press again to hang up the call.
c. long press to reject.
d. Quick press twice to recall your last dial out
phone number.
ANC Function
Press the ANC button to turn on the function. Press
again the ANC button to turn off the function.
When ANC ON, the indicator will turn on Green
light.
To be a wired Headphone
Plug in the Type-C cable included and connect to
your devices to be a wired headphone
Power Off
a.Long press 3 seconds the multi-function button.
A tone will be heard.
b.Automatically power off if fails to connect with
any device within 5 minutes (when ANC in OFF
status).
c.The headphone will automatically shut down
when charging.
Charging
On low power, a tone will be heard, indicating that
the headphone should be charged. The LED
indicator will turn RED while charging and turn
BLUE when fully charged.
Specification
Bluetooth Version: V6.0
Bluetooth Range: 33ft
Charging port: Type C
Play time: Up to 15 hrs when ANC ON and in max
volume. Up to 20 hrs when ANC OFF and in max
volume. (Varies depending on settings and usage)
Charging time: around 2 hrs
Battery capacity: 200mAh
Sensitivity: 105+/-2dB
Driver Size: 40mm
Impedance: 32 ohms
Frequency Response:20 Hz-20 kHz
FCC Statement
This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection
against harmful interference in a residential
installation. This equipment generates, uses and
can radiate radio frequency energy and, if not
installed and used in accordance with the
instructions, may cause harmful interference to
radio communications. However, there is no
guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful interference to radio or television
reception, which can be determined by turning the
equipment off and on, the user is encouraged to
try to correct the interference by one or more of
the following measures:
•Reorient or relocate the receiving antenna.
•Increase the separation between the equipment
and receiver.
•Connect the equipment into an outlet on a circuit
different from that to which the receiver is
connected.
•Consult the dealer or an experienced radio/TV
technician for help.
Caution: Any changes or modifications to this
device not explicitly approved by manufacturer
could void your authority to operate this
equipment.
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two
conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any
interference received, including interference that
may cause undesired operation.
RF Exposure Information
The device has been evaluated to meet general RF
exposure requirement. The device can be used in
portable exposure condition without restriction.
