Scan the QR code
1.Active the Lifetime Warranty
2.Get the Video“How to Connect”
3.Technical Support
If there is no connection for 15 minutes, the device will automatically power off
1
Blue light flashes
Blue light flashes
Blue light flashes Blue light flashes
Long press for 2 seconds to enter pairing/searching mode;
r 5
2
e
flash, indicating that the device is ready to connect to the second pair of headphones.
Press and hold the "Pairing" button on the device for 2 seconds. The status light will begin to
BR03 again for 2 seconds to re-enter pairing mode.
Galaxy Buds3 FE
Press and hold the pairing button on the Ultrbeka-
Bluetooth earphones
3
Hold the button for 5s to power on, then slide to
"TX" mode
,then
press the pairing button
Set AirPods 1 to pairing mode
Connection completed
Plug into the audio device
Hold the button for 5s to power on, then slide to "TX" mode,
Set AirPods 1 to pairing mode(refer to the AirPods 1 user manual for details).
then press the pairing
button.
e
5
30S
4
1
Press and hold the pairing button on the Ultrbeka-
BR03 again for 2 seconds to re-enter pairing mode.
e
Press and hold the "Pairing" button on the device for 2 seconds. The status light will begin to
flash, indicating that the device is ready to connect to the second pair of headphones.
5
6
7
The device's status light should begin to flash, indicating that the device has entered pairing mode (you
can enter pairing mode by pressing and holding the pairing button on the device for 2 seconds).
8
9
then slide to "RX" mode
Hold the button for 5s to power on,
.
Ultrbeka-BR03
Ultrbeka-BR03
"Ult
Hold the button for 5s to power on, then slide to "RX" mode;
rbeka-BR03"
of availa
e
5
10
t
Ultrbeka-BR03
Ultrbeka-BR03
"Ultrbeka-BR03"
Press and hold the pairing button on the product for 2 seconds
(Flashing Blue)
e
Ultrbeka-BR03
11
12
6.0
13
Any changes or modifications not expressly approved by the
party responsible for compliance could void the user’s
authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation
is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate
radio frequency energy, and if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following
measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for
help.
14
