Autoshutdown after 30 minutes of inactivity;
indicator light flashes red 3 times.
9.Type-C 插
9. Type-C port
孔
8. Reset
2. Press the "-" butto
3. Press the "+" button
n
2.按键“-”
1.开关按键
3.按键“+
8.复
1. Switch button
位
”
4
70 mm
7. V
The default volume is set to 50% upon startup.
8. Reset
When the machine malfunctions, press and hold the
power button for 8 seconds to automatically reset.
9. T
The charging cable interface defaults to charging the
device when a Type-C charging cable is inserted.
1. Wireless connectio
2. Memory functio
3. Built in lithium-ion batter
4. Supports decoding MP3 music forma
5. Use high fidelity speakers for a more natural
delicate sound
6.1+1 Device Connection Functio
42.5mm
n
and
t
y
n
n
10. Power-saving function
ype-C port
olume Requirements
1. Switch button
Press and hold the power button for approximately 2
seconds per operation.
Click: Play/Pause.
Double-click: TWS Pairing Mode
Double-click again to cancel
Triple tap: Disconnect the linked Bluetooth device.
Call: Click to answer incoming calls, click again to hang
up, or press and hold for 1.5 seconds to reject.
2. Press the "-" button
Click: Volume down. Long press: Previous track.
3. Press the "+" button
Click: Increase volume. Long press: Next track.
4. Indicator Light Status
powering on. Bluetooth pairing status: red and blue
lights alternate flashing, approximately 0.5 seconds per
cycle Connection status: Blue light flashes slowly at
The red light flashes slowly
5 seconds. In shutdown mode, the red light flashes
three times.
The red light turns on during charging and turns off
when fully charged.
6. V
6.1. There is a voice prompt when turning the device on/off
6.2. There is a voice prompt when the volume is
increased to the maximum, but no voice prompt
when it is decreased to the minimum.
6.3. Low battery (3.3V): Three low-bass prompts followed
by shutdown; red indicator light flashes slowly.
.
oice prompt
5. Charging indicator light
, approximately once every
approximately 5 seconds per cycle. Low battery status
TWS Pairing Mode.
二小时后使用
可长按开机按键8秒复位
Instruction Manual
。
。
H5
H5
H5
1.无线连接
2.记忆功能
3.内置锂离子电池
4.支持MP3音乐格式解码
5.使用高保真扬声器，声音更自然细腻
6 .1+1 设备串连功
H5
H5
能
4.指示灯状
蓝牙配对状态：红蓝交替闪，约0.5秒/次连接
状态：蓝灯慢闪 约5秒/次。 低电状态
红灯慢闪。约5秒闪烁一次。关机状态红灯闪烁3下。
上
态
1.开关按键
长按开关机 约2秒/次。
单击：播放/暂停。
双击：TWS对联模式 再次双击取消TWS对联模式。
三击：断开以链接的蓝牙设备。
通话：来电点击接听，在次单击挂断，长按1.5秒拒接。
2.按键“-”
单击：音量减 长按：上一曲。
3.按键“+”
单击：音量加 长按：下一曲。
4.指示灯状
蓝牙配对状态：红蓝交替闪，约0.5秒/次连接上
状态：蓝灯慢闪 约5秒/次。 低电状态
红灯慢闪。约5秒闪烁一次。关机状态红灯闪烁3下。
5.充电指示灯
充电时红灯亮 充满电 红灯灭。
6.语音提示
6.1.开/关机有语音提示音。
6.2.音量加到最大音量有语音提示，最小音量无语音提示。
6.3.低电3.3V低音提示3次 关机；指示灯红灯慢闪。
7.音量要求
开机默认音量50%。
8.复位
当机器出现异常情况时，长按开关机8秒自动复位。
9.Type-C 插孔
充电线接口， 插入Type-C充电线时， 默认为设备充电。
10.省电功能
无工作状态30分钟自动关机，指示灯红灯闪烁3下
H5
。
态
扬声器：31mm*1 4Ω5
输出功率：5
充电方式：Type-C 5V/500m
频率响应：70Hz-20Khz
A
W
W
电池：3.7V400mA
蓝牙版本：6.0
H5
H5
6
二
H5
every 5 seconds. The red light flashes three times in the
shutdown state
2. No response or malfunction of buttons: retry after shutt
down
3.When the machine encounters abnormal condition
press and hold the power button for 8 seconds to reset.
s,
,
ing
.
500m
4. Indicator light status
Bluetooth pairing status: red and blue flashing alternately
approximately 0.5 seconds/connection status: The blue
light flashes slowly for about 5 seconds/time. Low batt
stateThe red light flashes slowly. Flashing approximately
ery
,
H5
A
70Hz-20Khz
Any changes or modifications not expressly approved
by the party responsible for compliance could void
the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired
operation.
Note: This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against
harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio
frequency energy, and if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However,
there is no guarantee that interference will not occur in
a particular installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment
and receiver.
– Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
– Consult the dealer or an experienced radio/TV
technician for help.
6.0
