TWO WAY RADIO
Jiangnan High Technology Industry Park,
No.928 Nanhuan Road, Quanzhou, Fujian, China
Quanzhou Wouxun Electronics Co., Ltd.
FCC Statement
Any Changes or modifications not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions:
1) This device may not cause harmful interference.
2)This device must accept any interference received, including interference that may cause undesired
operation.
Note:
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used
in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the interference by one
or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
- Consult the dealer or an experienced radio / TV technician for help.
SAR tests are conducted using standard operating positions accepted by the FCC with the device
transmitting certified power level, the actual SAR level of the device while operating can be well
below the maximum value.
For body worn operation, this device has been tested and meets the FCC RF exposure guidelines
when used with for this product or when used with and accessory that contains no metal.
The maintain compliance with the FCC's RF exposure guidelines, hold the transmitter and antenna at
least 1 inch(2.5 centimeters) from your face and speak in a normal voice, with the antenna pointed up
and away from the face.,
This equipment complies with FCC radiation axposure limits set forth for an uncontrolled
environment. In order to comply with the FCC RF exposure requirements, the antenna installation
must comply with following:
Users must be fully aware of the hazards of the exposure and able to exercise control over their RF
exposure to qualify for the higher exposure limits.
Your wireless hand-held portable transceiver contains a low power transmitter. This product sends
out radiot Push-to-Talk (PTT) Button is pressed.
The device is authorized to operate at a duty factor not to exceed 50%.
TX: 462.5500-462.7250MHz:33dBm.
TX: 467.5625-467.7125MHz:26.81dBm.
RX: 400-480MHz.
