Loading ...
Loading ...
Loading ...
13
OPERATING INSTRUCTION
Starting Up
WARNING:
Prior to cleaning, make sure that the electric pressure washer is placed safely on level ground.
Impurities in the water can damage the high pressure pump and accessories.
All electric pressure washer (except hot water system) use the cold water. The suitable water
temperature is 32°F to 104°F.
Check the high pressure washer is assemble properly before connecting the pressure cleaner to
your cold water supply.
Make sure that the ON/OFF switch is in the OFF position.
Motor does not run continuously, only when the trigger is squeezed. Release the lever of the
trigger gun, the device will switch off again. Electric pressure washer remains in the system.
NEVER direct the high pressure water stream at people or animals!
Wear protective goggles and protective clothing during the cleaning process.
Bleeding The Gun
It is very important to bleed the gun before using the pressure cleaner.
To bleed the gun, simply connect the garden hose to the pressure cleaner and squeeze the trigger
BEFORE turning the electrical supply on. This allows any air trapped inside the pressure cleaner and
gun to be removed before using the unit. Continue holding trigger for approximately one minute to
allow any excess air out of the unit. Water will flow through the gun at low pressure during this
procedure.
Gun Safety Lock
This pressure cleaner is equipped with a gun trigger safety lock. When not
using the pressure cleaner, press the safety lock of the gun to keep from
accidentally engaging the high pressure spray. The gun trigger safety lock is
on the trigger gun as shown in the figure.
Switch ON/OFF
To switch ON the pressure washer
1. Press the trigger on the gun, turn on the water tap to expel the air inside the machine.
2. Plug in the power cord and turn on the switch knob to “I” position.
NOTE: The pressure cleaner will only run when the switch knob is in the ON position and the trigger
on the gun is squeezed. When you release the trigger to stop spraying water through the gun, the
motor on the pressure cleaner will automatically shut off. Simply squeeze the trigger again to resume
using the cleaner.
To switch off the pressure washer
1. Release the trigger.
2. Switch the unit to the OFF position by turning the switch knob to “O”
position.
NOTE: Press the safety lock out to avoid accident start. The unit should be
switch
knob
Loading ...
Loading ...
Loading ...