Samsung 1773873 Silver Stainless Smart Stacked Front Load Laundry Pair with WF53BB8900AT 27" Washer, DVG53BB8900T 27" Gas Dryer and SKK9MCT Stacking Kit

User Manual - Page 63

For 1773873.

PDF File Manual, 240 pages, Read Online | Download pdf file

1773873 photo
Loading ...
Loading ...
Loading ...
English
English63
Problem Action
Excessive suds.
Make sure you use the recommended types of detergent as appropriate.
Use high efficiency (HE) detergent to prevent oversudsing.
Reduce the detergent amount for soft water, small loads, or lightly
soiled loads.
Non-HE detergent is not recommended.
Cannot add additional
detergent.
Make sure the remaining amount of detergent and fabric softener is not
over the limit.
Stops.
Plug the power cord into a live electrical outlet.
Check the fuse or reset the circuit breaker.
Close the door, and tap and hold to start the washer. For your safety,
the washer will not tumble or spin unless the door is closed.
Before the washer starts to fill, it will make a series of clicking noises to
check the door lock and will do quick drain.
There may be a pause or soak period in the cycle. Wait briefly, and the
washer may start.
Make sure the mesh filter of the water supply hose at the water taps is
not clogged. Periodically clean the mesh filter.
If the washer is not supplied with sufficient power, the washer will
temporarily not drain or spin. As soon as the washer regains sufficient
power, it will operate normally.
Fills with the wrong water
temperature.
Fully open both taps.
Make sure the temperature selection is correct.
Make sure the hoses are connected to the correct taps. Flush water
lines.
Make sure the water heater is set to supply a minimum of 49 °C hot
water at the tap. Also, check the water heater capacity and recovery
rate.
Disconnect the hoses and clean the mesh filter. The mesh filter may be
clogged.
While the washer fills, the water temperature may change as the
automatic temperature control feature checks incoming water
temperature. This is normal.
While the washer fills, you may notice just hot and/or just cold water
going through the dispenser when cold or warm temperatures are
selected. This is a normal function of the automatic temperature control
feature as the washer determines the water temperature.
Untitled-1 63 2022-05-26  6:39:41
Loading ...
Loading ...
Loading ...