Loading ...
Loading ...
Loading ...
English
WARNING:
ELECTRICAL REQUIREMENT
-
SHOCK HAZARD
Electrical Requirement
•
Make sure there is a suitable power outlet (115 volts, 15 amps
outlet) with proper grounding to power the beverage cooler.
•
Avoid the use of three-prong adapters or cutting off the third grounding
prong in order to accommodate a two-prong outlet. This is a dangerous
practice since it provides no effective grounding for the beverage cooler and
may result in shock hazard.
Installation Limitations
•
Do not install your beverage cooler in any location that is heated or not
properly insulated (e.g., garage etc.). Your beverage cooler is not designed
to operate at an ambient temperature settings below 55˚ Fahrenheit.
•
Select a suitable location for the beverage cooler on a hard, even surface
away from direct sunlight or heat source (e.g., radiators, baseboard
heaters, cooking appliances, etc.). Any floor unevenness should be
corrected with the leveling legs located on the front and rear bottom
corners of the beverage cooler.
•
Your beverage cooler is designed for freestanding installation only. It is
not designed for built-in application.
Note: This unit is for indoor use only.
Use of Extension Cord
•
Avoid the use of an extension cord because of potential safety hazards
under certain conditions. If it is necessary to use an extension cord, use
only a 3-wire extension cord that has a 3-blade grounding plug and a 3-slot
outlet that will accept the plug. The marked rating of the extension cord
must be equal to or greater than the electrical rating of the appliance.
Loading ...
Loading ...
Loading ...