Loading ...
Loading ...
Loading ...
English
Installing Your Beverage Cooler
Unpacking Your Beverage Cooler
1.
Remove all packaging material. This includes the foam base and all
adhesive tape holding the beverage cooler accessories inside and
outside.
2.
Inspect and remove any remaining packing, tape or printed materials
before powering on the beverage cooler.
Leveling Your Beverage Cooler
•
Your beverage cooler has two leveling legs which are located in the
front corners. After properly placing your beverage cooler in its final
position, you can level your beverage cooler.
•
Leveling legs can be adjusted by turning them clockwise to lower your
beverage cooler or by turning them counterclockwise to raise your beverage
cooler. The beverage cooler door will close more easily when the two front
leveling legs are extended slightly.
Proper Air Circulation
•
Toensure that your beverage cooler works at the maximum efficiency
it was designed for, you should install it in a
location where there is
proper air circulation and electrical connections.
•
The following are recommended clearances around the beverage center:
Sides……………2" (50mm)
Top....................2" (50mm)
Back..................2" (50mm)
•
Do not overfill your beverage cooler for proper cooling.
Note:
If your beverage cooler has been tilted for any reason, wait 24 hours
before plugging it in.
Drip Tray
•
Ensure the drip tray in the rear of the unit is in the proper position.
Loading ...
Loading ...
Loading ...