Loading ...
Loading ...
Loading ...
Network Positioning System·Quick Start Guide
13
2 Installation
Before you start:
Check the package contents and make sure that the device in the package is in good
condition and all the assembly parts are included.
Notes:
Do not power the positioning system up until the installation is finished. To ensure
safety of personnel and equipment, all the installation steps should be done with
power supply off.
The positioning system is much heavier than the normal camera, and it strongly
demands for load-bearing and stability of the upholder. It’s highly recommended to
install the system to the upholder directly.
If you need to install the positioning system to the bracket, refer to bottom view of
the positioning system as shown in section 1.1 Introduction to select the bracket.
The load-bearing and anti-shake capabilities must be fully taken into consideration.
2.1 Installing DY9xxx Network Positioning System
2.1.1 Installing DY9xxx Series Laser Network Positioning System (Type III
and Type IV)
Steps:
1. Fix the positioning system.
1) Fix the positioning system onto the bracket pedestal with the supplied M8*30
screws as shown in Figure 2-1 and Figure 2-2.
Figure 2-1 Fix the Positioning System (Type III)
Loading ...
Loading ...
Loading ...