Loading ...
Loading ...
Loading ...
Service Transmission
Checking Transmission
The transmission is a sealed component. No maintenance is required
on this transmission. If you suspect any transmission problems, please
contact your authorized dealer.
TH84124,00001D2-19-12JUN15
Checking and Adjusting Neutral Creep
Checking Neutral Creep
Check neutral creep with engine running, motion control levers in the
start/shutdown position, park brake off, and machine on level ground.
If the machine creeps forward or reverses while motion control levers
are in the start/shutdown position, adjust the motion control lever
linkages.
Adjusting Neutral Creep
1. Park machine safely. (See Parking Safely in the Safety section.)
2. Remove style panel for better access to adjustment components (if
desired):
APY536681—UN—28APR22
a. Remove two bolts (A) to remove steering arm.
APY536682—UN—28APR22
b. Raise rear of seat and disconnect connector (B) from the seat
switch wiring harness connector. And remove two bolts (C) to
remove the seat.
APY536683—UN—28APR22
c. Remove four push retainers (D) from left side and three push
retainers (D) from right side of the style panel (E) and remove
the style panel(E).
GX535583—UN—21APR22
Right Side of Machine Shown with Machine Parts Removed for a Clearer Image
3. On linkage side needing adjustment (right side shown), remove
spring locking pin (E) and rod end (F) from pivot pin (G). Turn rod
end (F) on rod (H) in (clockwise) to decrease forward creep and out
(counterclockwise) to decrease reverse creep. Repeat procedure,
as necessary, on opposite side. Install rod ends back onto arms
and secure with spring locking pins.
4. Install style panel and push retainers, seat, seat switch, and
steering arm if previously removed.
GH8XT3T,00009C9-19-13JUN22
Adjusting Tracking
If the machine does not track in a straight line while moving in full
forward position, the tracking requires adjustment.
1. Park machine safely. (See Parking Safely in the Safety section.)
2. Use tracking adjustment socket found in the glove box of the
machine.
Service Transmission
33
Loading ...
Loading ...
Loading ...