Loading ...
Loading ...
Loading ...
6
8) For Top 3-1/4” x 10” Rectangular installation only:
- Remove the pre-installed Round Exhaust Plate (Refer to
Figure 5). Keep screws to attach Rectangular Exhaust
Plate and Rectangular Exhaust Adapter.
- Place Rectangular Exhaust Plate over vent and secure with
3 screws (Refer to Figure 6). Place Rectangular Exhaust
Adapter over the Rectangular Exhaust Plate and secure
with 2 screws (Refer to Figure 6).
- Use remaining screws to secure exhaust plate.
For Rear Vent Options Only:
NOTE: The blower is pre-installed for top vent. If installing as
rear vent, follow the steps below:
9) For Rear 6” Round installation only:
- Remove the Rear Vent Cover (Refer to Figure 4). Keep
screws to attach Round Exhaust Plate to rear vent.
- Remove the pre-installed Round Exhaust Plate from top
vent (Refer to Figure 5). Attached it to the rear vent (Refer
to Figure 7) using screws removed from vent cover.
- Use the vent cover removed from rear vent to seal top vent.
- Remove the 4 screws that secure the blower system (Refer
to Figure 8). Hold the blower to keep it from dropping as
you remove screws. Keep screws to re-attach blower.
Slowly rotate blower system to align with mounting holes at
the back of the insert. Secure blower using 4 screws (Refer
to Figure 9).
10) For Rear 3-1/4” x 10” Rectangular installation only:
- Remove the Rear Vent Cover (Refer to Figure 4). Keep
screws to attach Rectangular Exhaust Plate and
Rectangular Exhaust Adapter.
- Place the Rectangular Exhaust Plate over vent and secure
with 3 screws (Refer to Figure 10). Place Rectangular
Exhaust Adapter over the Rectangular Exhaust Plate and
secure with 2 screws (Refer to Figure 10).
- Use remaining screws to secure exhaust plate.
- Remove the pre-installed Round Exhaust Plate from top
vent and keep screws (Refer to Figure 4). Use the vent
cover removed from rear to seal top vent.
- Remove the 4 screws that secure the blower system (Refer
to Figure 8). Hold the blower to keep it from dropping as
you remove screws. Keep screws to re-attach blower.
Slowly rotate blower system to align with mounting holes at
the back of the insert. Secure the blower using 4 screws
(Refer to Figure 9).
Figure 5
Figure 6
Figure 7
Figure 8
Figure 9
*Note: Sample image only. May not be actual model.
*Note: Sample image only. May not be actual model.
*Note: Sample image only. May not be actual model.
*Note: Sample image only. May not be actual model.
*Note: Sample image only. May not be actual model.
Loading ...
Loading ...
Loading ...