Loading ...
Loading ...
Loading ...
5
Preparation Before Installation
Figure 1
Figure 2
Figure 3
INX2630SQB-700-3 (30”)
INX2636SQB-700-3 (36”)
Figure 4
NOTE: TO AVOID DAMAGE TO YOUR HOOD, PREVENT
DEBRIS FROM ENTERING THE VENT OPENING.
• Decide the location of the venting pipe from the hood to the
outside. Refer to Figure 1.
• A straight, short vent run will allow the hood to perform more
efficiently.
• Try to avoid as many transitions, elbows, and long run as
possible. This may reduce the performance of the hood.
• Temporarily wire the hood to test for proper operation before
installing.
• Important: Peel protective film off the hood, if any.
• Use duct tape to seal joints between pipe sections.
CAUTION: If moving the cooking range is necessary to
install the hood, turn off the power in an electric range at
the main electrical box. SHUT OFF THE GAS RANGE
MOVING A GAS RANGE. And use a protective covering to
protect cooktop and/or countertop from damage.
Customer Hood Preparation
1) The custom hood frame must be designed according to the
shape and the weight of the insert. Refer to Measurements &
Diagrams on Page 11.
2) A sturdy base (3/4-inch think plywood recommended) is needed
to sustain the weight of insert.
3) It is recommended to install front & rear stud support (not
included). Refer to Figure 2. For safety purposes, extra
installation holes on the side of the insert are provided. Prepare
the side stud support if needed.
4) Determine and mark the centerlines on the base of the hood
frame where the insert will be installed.
5) Determine the proper location for the Power Supple Cable.
Make a wiring access hole using a drill bit. Install the wire cable
and seal the gap around hole.
6) Cut out the opening where the insert will be installed.
(Figure 3)
Hood Preparation Before Installation
CAUTION: If moving the cooking range is necessary to
install the hood, turn off the power in an electric range at
the main electrical box. SHUT OFF THE GAS BEFORE
MOVING A GAS RANGE.
7) Choose the required vent option. The Round Exhaust Plate is
pre-installed for top vent.
*Note: Sample image only. May not be actual model.
Loading ...
Loading ...
Loading ...