Loading ...
Loading ...
Loading ...
7
Ductwork Installation
Figure 10
Figure 11
Figure 12
Figure 13
11) Determine and make all necessary cuts in the wall or ceiling for
the ductwork. NOTE: Install the ductwork before installing the
insert.
12) Use steel pipe to connect the exhaust on the hood to the
ductwork above. Use duct tape to make all joints secure and
air tight.
13) Please refer to local codes for the usage of a damper (included).
Electrical Wire
14) Connect the range hood to an outlet.
15) If hardwired is desired, cut off the plug and connect three wires
(black, white, green) to the outlet wires and cap with wire
connectors. Connect the wires according to color (ex: black to
black)
Hood Installation
NOTE: USE HAND TOOLS ONLY. DO NOT OVER TIGHTEN
SCREWS. IT MIGHT CAUSED DAMAGED TO THE
HOOD.
16) Remove 10 screws located at the bottom of the insert (Refer to
Figure 11). Carefully remove the light support panel.
17) Position the insert inside the custom wood frame and secure
the insert to the front and rear stud support (Refer to Figure 2)
by using the front and rear mounting holes (screws included).
18) For a more secure installation, use the mounting holes located
on the side of the insert.
19) Make sure insert is secure before releasing.
20) Re-install the light support panel. (Do not tighten screws)
CAUTION: MAKE SURE HOOD IS SECURE BEFORE
RELEASING.
Final Assembly
21) Install the oil tunnel into recess support near rear of hood. Refer
to Figure 12.
22) Install baffle filters. Angle baffle filter toward back of hood ①.
Push baffle filter up until almost level ②. Slide forward into
recess behind the front of hood ③. Lower baffle filter ④. Slide
back until it fits into resting position ⑤. Refer to Figure 13.
*Note: Sample image only. May not be actual model.
*Note: Sample image only. May not be actual model.
Loading ...
Loading ...
Loading ...