Loading ...
Loading ...
Loading ...
5.1 Pre-Installation
5.2 Safety Distance
Cooking appliance Min. Distance
Electric cooktop
(AU, NZ)
Electric grill, deep fat fryer (electric) 650 mm
600mm
Multi-
MJ/h total output, with no burner having a
greater output than
16.2 MJ/h.
650 mm
Multi-burner gas cooktop with total output
greater than 45.4 MJ/h, but with a maximum
of 77.8 MJ/h, with no burner having a greater
output than 17.3 MJ/h.
760 mm
Multi-burner gas cooktop with total output
greater than 77.8 MJ/h, with a single burne
r
having a greater output than 17.3 MJ/h.
Not possible
Single burner gas cooktop with a maximum
output of 21.6 MJ/h.
650 mm
Single burner gas cooktop with an output
greater than 21.6 MJ/h, but with a maximum
of 29.2 MJ/h.
760 mm
Single burner gas cooktop with an output
greater than 29.2 MJ/h.
Not possible
5.3 Installation [External Ventilation]
Mounting of V-flap
Before installation, it is important to read the information given on
the following pages as well as the "General Safety Instructions" at
the beginning of this booklet. Failure to install the appliance
correctly could invalidate any warranty or liability claims and lead
to prosecution.
If you are fitting a front panel made of wood or plastic to the
rangehood, observe the safety distances given by the cooktop
manufacturer regarding the use of easily flammable materials.
To achieve optimum vapor extraction, the rangehood must
cover the cooktop. It should be positioned centrally over the
cooktop, not to the side.
The cooktop should be no wider than the rangehood and, if
possible, it should be narrower, especially for safety distances
greater than 750 mm.
The installation area must be easily accessible. The rangehood
should be easily accessible and easy to dismantle in the event
that service is required.
This should be taken into consideration
when planning the position of cupboards, shelves, ceilings or
features in the vicinity of the rangehood.
If the rangehood does not have a pre-assembled V-flap, install
the parts as follows:
1. Install the first half into the housing
2. The pin should be facing upwards.
3. The axle is inserted into the holes on the housing.
4. Repeat all the steps for the second half of the flap.
Before installing the rangehood, peel off any protective
plastic covering and remove polystyrene from inside
behind the fan motor.
The minimum distances between the highest part of a
cooktop (including trivets, dials - depending on model)
and the bottom of the rangehood are as follows, unless a
greater distance is specified by the manufacturer of your
cooking appliance. See also "General Safety instructions"
section.
5.3. Installation Tips
Note direction
when attaching
1 2
Flaps
Housing
5. INSTALLATION
6
If you have an air outlet to the outside, the
rangehood can be connected via an extraction
duct (enamel, aluminium, flexible pipe or
non-combustible material with an internal
diameter of 150 mm) as shown on the left.
Loading ...
Loading ...
Loading ...