Loading ...
Loading ...
Loading ...
Setting the timer
The remote control must establish a new connection with
the rangehood in order to be used.
Pairing the Remote Control
Pairing the Remote Control
6.2 Remote Control and Features
6.3 Pairing remote control with your Appliance
6.4 Energy Saving tips
Light Button
Reduce speed
Timer button
Increase speed
Press the LIGHT button to switch on the light. Press the
button again to switch it off. The light is independent
of other functions.
Each time you press the [-] button, the speed is
decreased. The display indicates the corresponding
speed. If you want to switch off the motor,
press the [-] button until the motor stops.
Press the TIMER button to activate the timer function.
The timer is initially set to 5 minutes. Each time you
press [+], the time is increased by 1 minute. Each
time you press [-], the time is reduced by 1 minute.
A time of 1-60 minutes can be set.
Once you have set the timer, press the TIMER button
again to confirm or wait 10 seconds until the set time
is automatically. The motor runs until the time you set
runs out, then it switches off automatically.
In case you want to use the timer with the same time,
just press the TIMER button and then wait 10 seconds.
If you want to enter a different time, proceed as
described in steps 1 and 2.
Each time you press the [+] button, the speed is
increased to the next level. The display indicates the
corresponding speed. If you want to switch off the
motor, press the [-] button until the motor stops.
Turn the rangehood on and long press the power
button for 5 seconds. The indicators light will flash
from one button to another which means the range-
hood is in connection mode.
Press any button on remote control to confirm the
connection. The remote control can be used to control
the rangehood: power on/off, speed control, light,
timer.
This rangehood operates very efficiently and economically.
The following will help you to save even more energy when
using it:
Ensure that there is sufficient ventilation in the kitchen
when cookin
g. In extraction mode, if there is
insufficient air flow the rangehood cannot operate
efficiently and this causes increased operating noise
levels.
Always cook with the lowest possible setting. This
produces fewer cooking vapors, so you can use a
lower rangehood power level and therefore benefit
from reduced energy consumption.
Check the power level selected on the rangehood. A
lower power level is generally sufficient for the majority
of cooking. Only use the Booster setting when
necessary.
When a large volume of cooking vapors is being
produced, switch to a high-power level in good time.
This is more efficient than operating the rangehood
for longer to try to capture cooking vapors which have
already been distributed throughout the kitchen.
Make sure that you sw
itch the rangehood off after use.
Clean or change the filters at regular intervals. Heavily
soiled filters reduce performance, increase the risk of
fire and are unhygienic.
To establish a new connection, you will need to reset
the previous connection.
To reset the existing connection, long press the power
button on the rangehood for 5 seconds. The indica-
tors light will flash from one button to another. Then
long press the power button for 5 seconds again so
that the existing connection is cleared.
Once the previous connection is reset, the rangehood
will go into standby mode. Then, repeat the steps
above to connect the rangehood to a new remote
control.
increase
reduce
Timer Light
If you want to end an active timer prematurely, press the TIMER
button while the timer is running.
NOTE
10
www.linarie.com.au
Loading ...
Loading ...
Loading ...