Loading ...
Loading ...
Loading ...
13
cont. cleaning and maintenance
Make sure that the filter is tightly closed. It can otherwise detach
and become dangerous. If an activated carbon filter is connected,
the suction power is reduced.
The lamps become hot when in use. Allow the lamps to cool
down completely before changing them.
The lamp must be replaced by the manufacturer, its after-sales
service or similarly qualified persons.
Always switch off the power supply before carrying out any work
on the appliance.
Always hold the lamp with a cloth or gloves when inserting or
removing it to ensure that sweat does not come into contact with
the lamp, as this can reduce its life.
If the rangehood is connected for recirculation, a charcoal
filter must be inserted in addition to the grease filter. This
is designed to absorb cooking odors.
The installation of the activated carbon filter is done as
follows:
Disconnect the rangehood from the power supply
before installation.
Press the filter lock and remove the main filter.
Rotate the carbon filter counter-clockwise on both
sides of the motor. Replace the old carbon filters with
new carbon filters.
Replace the main filters.
Reconnect t
he power supply.
The activated charcoal filter should be changed after 3 to
6 months, depending on your cooking habits. Allow the
appliance to cool down completely before maintenance.
Replacement charcoal filters can be obtained from
www.linarie.com.au
The used activated charcoal filter can be disposed with the
normal household waste.
Observe all safety and warning information during
operation (see the “General Safety Instructions”
section).
The lamps should be re
placed with the following:
ILCOS D code: DSR-1-S-41
LED Type: Round Glass Lamp
Wattage: 2 x 1 W
Voltage Range: DC 4V
Dimensions:
Disconnect the rangehood from the mains electrical
supply before replacing the lamps
Rotate the cover counter-clockwise. Loosen the screw
of the stainless-steel filter and remove it.
Press the light connector to remove the light bulb.
Install the new light and reconnect the cable.
8.6 Activated carbon filter
8.7 Replacing the lamps
To replace the lamps:
Installing and replacing the activated charcoal filter
When to change the activated charcoal filter?
Disposing of the activated charcoal filter
close
open
1 2 3 4 5
41
Loading ...
Loading ...
Loading ...