Loading ...
Loading ...
Loading ...
26
Option A: Waste disposer – no air gap
A
B
C
D
A. Disposer inlet
B. Drain trap
C. Drain hose
D. Drain hose clamp (red
color)
Helpful Tip: Remove disposer knockout plug.
1. Fit rubber end (A) of drain hose to waste tee and cut if
needed.
A
A. Two cut lines
NOTE: Do not cut ribbed section.
2. Using a hammer and screwdriver, knock plug into disposer.
3. Use needle-nose pliers to remove plug.
4. Attach drain hose to disposer inlet with drain hose clamp (red
color) (provided). Use pliers to squeeze clamp open and move
into position.
Option B: No waste disposer – no air gap
A
B
C
D
A. Waste tee
B. Drain trap
C. Drain hose
D. Drain hose clamp (red
color)
1. Fit rubber end (A) of drain hose to waste tee and cut if
needed.
A
A. Two cut lines
NOTE: Do not cut ribbed section.
2. Attach rubber end of drain hose to waste tee with a drain hose
clamp (red color) (provided). Use pliers to squeeze clamp
open and move into position. If the drain hose was cut, use a
1
1
/
2
" to 2" (38 mm to 50 mm) screw-type clamp (not provided).
26-Jun-2023 08:47:55 EDT | RELEASED
In some European factories the letter "W" of the part code mentioned herein will be automatically
replaced by the number "4000" (e.g. "W12345678" becomes "400012345678")
Loading ...
Loading ...
Loading ...