Loading ...
Loading ...
Loading ...
CONTROL PANEL | INDICATOR LIGHTS AND BUTTONS
A
Ice Full Indicator
B
Water Shortage Indicator Light
C
Cleaning Operation Indicator
D
Power Indicator
E
Clean Button
F
Internal Light Ice Drawer Switch
G
Power Button
A B C D
E F G
ICE FULL INDICATOR - When the ice drawer is full, the ICE FULL indicator with illuminate. The indicator will remain
lit until the ice in the drawer with melts away slowly or has been removed. The unit will stay in Standby mode until
the ice has been removed or melted at which time the unit will automatically start operation as normal.
ADD WATER INDICATOR - The ice maker automatically checks the water level in the water reservoir. If the water
level is too low, the ADD WATER indicator will illuminate and the ice make will stop working automatically. Once
water is added to the reservoir, the indicator will turn off and the ice maker will resume normal operation.
CLEANING INDICATOR - Press the Clean Button to initiate Cleaning Mode. In Cleaning Mode, water flows from
the upper water tank to the evaporator and back to the lower water tank (water circulation). After the water pump
runs for 7 minutes, the cleaning mode is completed, and the system enters standby mode. See Page 8 for further
instructions.
NOTE: Ensure that the water level in the reservoir is at the maximum level. If the water level is insufficient, the ADD
WATER indicator will illuminate, indicating the need for more water to initiate the Cleaning Mode. Once water has
been added, restart the cleaning process by pressing the Clean Button.
INTERNAL LIGHT BUTTON - Press the Light Button to toggle the internal light of the ice drawer on or off. The light
automatically turns off after 10 minutes.
POWER INDICATOR - Press the Power Button to turn the unit on. While the ice maker is operation, the Power
Indicator remains illuminated. To turn off the ice maker or put it in Standby Mode, press the Power Button. The ice
maker enters Standby Mode when the Power Indicator flashes.
ICE JAM AND FREEZE WARNING- If the ADD WATER light, ICE FULL indicator light, CLEANING indicator light,
and POWER indicator light flash simultaneously, it indicates a freezing alarm or an ice jam in the ice-making system.
In this situation, disconnect the power and wait for 4 hours until the ice inside the evaporator melts. After this
period, either manually run the cleaning function six times (for a total of 40 minutes) or wait for the ice particles in
the evaporator to completely melt at room temperature. Once the ice has melted, press the POWER Button to
restart the machine and enter normal operation.
NOTE: For further assistance with this warning, please contact Whynter Customer Support at [email protected]
Loading ...
Loading ...
Loading ...