Loading ...
Loading ...
Loading ...
HEDGE TRIMMER ATTACHMENT — HTA2000/HTA2000-FC/HTA2020/HTA2020-FC 25
REPLACING THE BLADE
WARNING: Always wear gloves when handling the blade; these components are
very sharp and may contain burrs.
1. Stop the motor and remove the battery pack.
2. Adjust the blade to the horizontal position, ensuring that the blade assembly is in
line with the hedge trimmer shaft for easy mounting (Fig. 14).
3. Use a hex wrench (not included) to loosen the 6 screws (short screws) in the
bottom cover and remove them.
4. Continue loosening the 2 screws (long screws) to remove the support plate 1 & 2,
as well as the 2 bushings. The 2 bushings are separately located inside the two
rounded rectangle slots in the blade assembly.
5. Remove the support plate 3.
6. Carefully remove the link lever from the blade.
7. Remove the blade assembly from the tool and replace it with a new one.
8. Align the inward bulge on the new blade assembly with the hole inside the
eccentric block assembly to install the new blade assembly into place.
9. Insert the two bushings into the two rounded rectangle separately.
14
Short Screw
Bottom Cover
Support Plate 3
Long Screw
Link Lever
Support Plate 2
Support Plate 1
Blade Assembly
Eccentric Block Assembly
Bushing
Loading ...
Loading ...
Loading ...