Sun Joe SPX2790-MAX Electric Pressure Washer 2200 PSI Rated Pressure Included Foam Cannon

Operator's Manual - Page 9

For SPX2790-MAX.

PDF File Manual, 56 pages, Read Online | Download pdf file

SPX2790-MAX photo
Loading ...
Loading ...
Loading ...
9
mWARNING! Keep hose away from sharp objects. Bursting
hoses may cause injury. Examine hoses regularly and replace if
damaged. Do not attempt to mend a damaged hose.
9. Connect the garden hose adapter (female coupler) to the
water inlet of the pressure washer, then thread your garden
hose (male end) into the garden hose adapter
(Fig. 9).
The garden hose must have an internal diameter of at least
13 mm (1/2 in.) and must be reinforced. The water supply
must be at least equal to the washer delivery capacity.
NOTE: The machine is not suitable for connection to the
potable water main.
10. Attach garden hose to water supply (Fig. 10).
mWARNING! Do not connect to potable water system.
mWARNING! If connection is made to a potable water
system, the system shall be protected against backflow.
mWARNING! The intake water temperature must not exceed
104°F/40°C. The water supply must not exceed 0.7 MPa.
mCAUTION! The washer must only be used with clean
water; use of unfiltered water containing corrosive chemicals will
damage the washer.
Operation
Using the Pressure Washer
mIMPORTANT! This pressure washer is equipped with
a micro-switch sensitive to water flow. This Total Stop System
(TSS) senses water flow in the pump. When the trigger is
released, water stops flowing through the pump. The TSS then
automatically turns the motor off to protect the pump from
overheating, thus saving energy and prolonging pump life.
1. Position the washer as CLOSE as possible to the
water supply.
2. The washer must be used on a secure and stable surface in
a standing, upright position (Fig. 11).
3. Make sure the unit is switched off before plugging the unit
into the power outlet.
4. Check that the electrical supply voltage and frequency
(Volt/Hz) correspond to those specified on the rating
plate. If the power supply is correct, you may now plug the
pressure washer into the power outlet (Fig. 12).
Fig. 9
Garden hose
This end to
water inlet
Garden hose
(male end)
Water inlet
Fig. 10
Connect to water supply
Garden hose
Fig. 11
RESET
TEST
Fig. 12
GFCI
Reset
Loading ...
Loading ...
Loading ...