Sun Joe SPX2790-MAX Electric Pressure Washer 2200 PSI Rated Pressure Included Foam Cannon

Operator's Manual - Page 10

For SPX2790-MAX.

PDF File Manual, 56 pages, Read Online | Download pdf file

SPX2790-MAX photo
Loading ...
Loading ...
Loading ...
10
NOTE: The GFCI may need to be reset when first plugged into
the electric outlet. Press the "Reset" button until the power
light indicator on the GFCI illuminates when plugged in.
5. Turn the water supply tap on completely.
6. Make sure the safety lock is down and in its original
position, then press the trigger for a few seconds until water
flow is steady. This will allow air to escape and discharge
any residual pressure in the hose (Fig. 13).
7. Turn the ON/OFF switch to the ON (I) position to start the
pressure washer (Fig. 14).
8. When re-starting the motor, always keep the trigger
pressed.
NOTE: The motor only runs when the trigger is operated
and shuts off when the trigger is released.
Using Nozzles
Before beginning any cleaning task, determine the best nozzle
for the job. Each of the nozzles has a different spray pattern.
The nozzle patterns are 40° (for gentle cleaning), 15° (for tough
jobs), and 0° (for spot cleaning or hard-to-reach areas).
mCAUTION! NEVER change nozzles without locking the
safety lock on the trigger handle.
mWARNING! High-pressure jets can be dangerous if
subject to misuse. The jet must not be directed at persons, pets,
live electrical equipment, or the appliance itself.
This electric pressure washer is equipped with three (3) Quick-
Connect nozzles that easily snap onto the Quick-Connect collar
of the stainless steel lance.
To connect a nozzle to the spray wand:
1. Turn off the pressure washer and shut off the water supply.
Pull the trigger to release water pressure.
2. Engage the safety lock on the trigger handle by pushing up
on the safety lock until it clicks into the slot (Fig. 15).
3. Snap the desired nozzle onto the Quick-Connect collar until
it clicks into place (Fig. 16).
To disconnect a nozzle from the spray wand once the cleaning
job is complete:
1. Turn off the pressure washer and shut off the water supply.
Pull the trigger to release water pressure.
2. Engage the safety lock on the trigger handle by pushing up
on the safety lock until it clicks into the slot (Fig. 15).
3. Remove the nozzle by placing your hand over the nozzle
while pulling back on the Quick-Connect collar.
Fig. 13
Safety lock
Slot
Trigger
Fig. 14
ON/OFF switch
Fig. 15
Safety lock
Slot
Fig. 16
Nozzle
“Click”
Quick-Connect collar
Stainless steel
lance
Loading ...
Loading ...
Loading ...