Loading ...
Loading ...
Loading ...
14
15
EN
EN
Clean the Main Brush
Clean the Side Brush
Clean the Main Wheel / Omnidirectional Wheel
Routine Maintenance
Press the brush guard clips inwards to remove the brush guard and lift the
brush out of the robot.
Pull out the side brushes and use the included cleaning tool to remove any hair
tangled on the brush.
Pull out the brush covers as indicated by the diagram. Use the included
cleaning tool to remove any hairs tangled on the brush.
Note: Do not pull out the hair excessively to avoid the damage of brush when the hair is
tightly tangled on the brush.
Note: Use tools such as a small screwdriver, etc. to separate the axle and the tire.
Clean the Mopping Module
Routine Maintenance
1. Press the two release clips on the side of water tank, remove the mopping
module and pull the mop pad off the mopping module.
3. Clean the mop pad with water only and leave to air dry before re-installing.
2. Pour out the water in the tank. Clean with water only and leave to air dry
before re-installing.
4. If slow water flow occurs, or the volume is not well-distributed, please
clean the air hole in the cover of the water tank.
Note: Do not use any cleaning agents or disinfectants.
Note:
•
Remove the pad from the mopping module before cleaning it, and make sure dirty
water does not flow back into the water outlet to avoid clogging.
•
For optimal performance, it is recommended to replace the mop pad every 3 to 6
mouths.
Loading ...
Loading ...
Loading ...