Loading ...
Loading ...
Loading ...
BPRZR2S
IPX6 RATED 200 WATTS TRUE PLUG-N-PLAY
POLARIS RZR TWO SPEAKER AUDIO SYSTEM
INSTALLATION MANUAL
- 6 -
Audio Receiver (BPS1RS) Installation
Important notes:
• See “Installation Precautions” on page 2.
• Disconnect the negative terminal of the vehicle battery prior to wiring.
• Consult an expert when in doubt about installation of the audio receiver.
1. Remove the hood and the dash in your RZR to access the bus bar and the rocker switch location. See
“Disassembly” on page 4 for details.
2. Simply insert the audio receiver into an available rocker switch location.
If a rocker switch location is not available, cut a rectangular hole (W x H: 0.85” x 1.45”) in the dash. Then
directly t the audio receiver in the hole.
Important: When cutting the hole in the dash, verify any wiring in the dash cavity will not be damaged.
3. Connect the power and ground wires of the audio receiver to the bus bar. Route the “POWER+” wire (red)
and “GROUND-” wire (black) out of the rewall through the rewall grommet. Then connect the two wires to
the bus bar, the red wire to the positive terminal and the black wire to the negative terminal.
Note: For BPRZR2S installation, only power and ground harnesses will be routed out of the dash cavity
through the rewall.
Speaker (RZR-FSA) Installation
The included two speakers are designed to be installed near the footwell in your Polaris RZR, the left/amplied
speaker on the driver side and the right speaker on the front passenger side.
Important notes:
• See “Installation Precautions” on page 2.
• Disconnect the negative terminal of the vehicle battery prior to wiring.
• Consult an expert when in doubt about installation of the speakers.
1. Remove the driver and front passenger seat, and remove the hood and the dash in your RZR to access the
bus bar and the dash cavity. See “Disassembly” on page 4 for details.
2. Install the right speaker (with no wire harness) near the footwell on the front passenger side.
Loading ...
Loading ...
Loading ...