Loading ...
Loading ...
Loading ...
INSTALLATION MANUAL
BPRZR2S
IPX6 RATED 200 WATTS TRUE PLUG-N-PLAY
POLARIS RZR TWO SPEAKER AUDIO SYSTEM
- 3 -
A
B
C
D
E
F
Audio receiver
(BPS1RS)
RZR-FSA speakers
Left
(amplied)
Right
A
: Connect the “MAIN OUT” sockets of the audio receiver to the “LINE IN” plugs (red/white) of the left
speaker. Make sure to match the connector color. This will allow output audio from the audio receiver
(BPS1RS) to the speakers (RZR-FSA).
B
: Connect the “REMOTE OUT” wire (blue) of the audio receiver to the “REM” wire (blue) of the left speaker.
This can control turn-on/turn-off of the speakers whenever the audio receiver is turned on or off.
C
: Connect the power and ground wires of the left speaker to the bus bar in your Polaris RZR, the “+12V” wire
(red) to the positive terminal and the “GND” wire (black) to the negative terminal. Make sure the ring
terminals are properly secured to the bus bar with the factory hardware.
D
: Connect the left and right speakers together, using the “OUTPUT” wires attached to each speaker.
E
: Connect the power and ground wires of the audio receiver to the bus bar in your Polaris RZR, the
“POWER+” wire (red) to the positive terminal or ACC power terminal and the “GROUND-“ wire (black) to
the negative terminal. Make sure the ring terminals are properly secured to the bus bar with the factory
hardware.
F
: Using a 3.5 mm audio cable (not included), connect the “AUX IN” socket (3.5mm) of the audio receiver to
the headphone jack on your mobile device (e.g. mobile phone or MP3 player).
Loading ...
Loading ...
Loading ...