Loading ...
Loading ...
Loading ...
9
INSTALLATION INSTRUCTIONS
WARNING: Installation and service must be performed by a qualified installer, service agency or the gas
supplier. Failure to do so can result in death, fire, or electrical shock.
IMPORTANT: Save these instructions for local electrical inspectors use. Read and save these instructions for
future use.
WARNING: Installations for Gas and Electric
The cooktop is manufactured for use with Natural Gas. The cooktop can be converted for use with propane
gas using the propane conversion kit supplied with the cooktop.
Be sure the cooktop being installed is correct for the type of gas being used.
Refer to the rating plate located on the underside of the burner box.
When connecting the unit for propane gas, make certain the propane tank is equipped with its own high
pressure regulator.
In addition, the pressure regulator supplied with the cooktop must be installed on the gas inlet pipe going
to the cooktop.
INSTALLING COOKTOP
1. Use as 24” or deeper base cabinet.
2. Cut the opening in the countertop.
To ensure accuracy it is best to
make a template for the opening.
Make sure the sides are parallel
also rear and front cuts are exactly
perpendicular to the sides. Keep
in mind all minimum clearances.
(Refer to Figure 6.)
3. Before installing the cooktop into
the opening in the countertop,
remove all grates and burner caps.
4. Turn the cooktop upside down
and place the special foam gasket
around the bottom edge of the
cooktop. It is important that the
gasket is fixed evenly without
any gaps or overlapping, this is to
prevent liquid seeping underneath
the cooktop. (Refer to Figure 7.)
5. After the foam gasket is installed,
place the cooktop into the
countertop. (Refer to Figure 6.)
6. Secure the cooktop from
underneath with the supplied clips
and screws. (Refer to Figure 8.)
Figure 6
Figure 7 Figure 8
Underside of Cooktop
Clip
Screw
Foam Gasket
Underside of Countertop
300 mm)
20” (510 mm)
3.6” (91 mm)
6” (150 mm)
3” (75 mm)
19
” (490 mm)
11” ( 0 mm)
Loading ...
Loading ...
Loading ...