Loading ...
Loading ...
Loading ...
Chapter 64 Static Route
XGS2220 Series User’s Guide
483
64.3.1 Add/Edit IPv6 Static Route
Click Add/Edit, or select an entry and click Add/Edit in the NETWORKING > Static Routing > IPv6 Static
Route to display this screen.
Figure 390 NETWORKING > Static Routing > IPv6 Static Route > Add/Edit
The following table describes the related labels you use to create a static route.
Select an entry’s check box to select a specific entry. Otherwise, select the check box in the
table heading row to select all entries.
Add/Edit Click Add/Edit to add a new entry or edit a selected one.
Delete Click Delete to remove the selected entries.
Table 249 NETWORKING > Static Routing > IPv6 Static Route (continued)
LABEL DESCRIPTION
Table 250 NETWORKING > Static Routing > IPv6 Static Route > Add/Edit
LABEL DESCRIPTION
Interface Type Select the type of the IPv6 interface through which the IPv6 packets are forwarded.
The Switch supports only the VLAN interface type at the time of writing.
Interface ID Enter the ID number of the IPv6 interface through which the IPv6 packets are forwarded.
Route
Destination
Enter the IPv6 address of the final destination.
Prefix Length Enter the prefix length number of up to 64 for this destination.
Next Hop Enter the IPv6 address of the next-hop router.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Clear Click Clear to clear the fields to the factory defaults.
Cancel Click Cancel to not save the configuration you make and return to the last screen.
Loading ...
Loading ...
Loading ...