Loading ...
Loading ...
Loading ...
Entrance/Exit Ticket Station User Manual
28
Step 4 Click Save.
7.4 Configure RS-232
Set RS-232 parameters if you need to debug the device via RS-232 serial port, or peripheral devices
have been connected.
Before You Start
The corresponding device has been connected via the RS-232 serial port.
Steps
Step 1 Go to Configuration > System Settings > RS232.
Figure 7-3 Set RS-232
Step 2 Set Baud Rate, Data Bit, Stop Bit, etc.
The parameters should be same with those of the connected device.
Step 3 Click Save.
7.5 Reboot
You can reboot the station.
Step 1 Go to Configuration > System > Maintenance > Upgrade & Maintenance > Reboot.
Figure 7-4 Reboot
Step 2 Click Reboot.
Step 3 Click OK on the popup window to reboot the station.
Loading ...
Loading ...
Loading ...