Loading ...
Loading ...
Loading ...
●
Switching between 12-hour and 24-
hour Timekeeping
You can specify either 12-hour format or 24-
hour format for the time display.
1. Enter the Timekeeping Mode.
l
Navigating Between Modes
2. Press (A).
This causes the seconds to flash.
Seconds
3. Press (L) to select 12-hour or 24-hour
timekeeping.
Each press of (L) toggles between 12-
hour and 24-hour timekeeping.
●
[P] is displayed during p.m. times while
12-hour timekeeping is being used.
24-hour timekeeping12-hour timekeeping
4. Press (A) to complete the setting
operation.
Note
●
While the setting is being configured,
the watch will exit the setting operation
automatically after about two or three
minutes of non-operation.
Alarm
The watch will beep when an alarm time is
reached.
The hourly time signal causes the watch to
beep every hour on the hour.
●
If flash alert is enabled, display illumination
will flash along with the alarm beeper and
the hourly time signal.
l
Configuring Flash Alert Settings
Configuring Alarm Settings
There are various alarm variations, and the
variation that is set depends on the hour,
minute, month, and day settings you
configure.
●
Configuring Some of the Settings (hour,
minute, month, day)
ー
Hour and Minute Settings Only
The alarm sounds every day at the
specified time.
ー
Month, Hour and Minute Settings Only
The alarm sounds every day of the
specified month at the specified time.
ー
Day, Hour and Minute Settings Only
The alarm sounds every month at the
specified time on the specified day.
●
All Settings: Hour, Minute, Month, Day
The alarm sounds once at the specified time
on the specified date.
1. Enter the Alarm Mode.
l
Navigating Between Modes
2. Press (A).
This causes the hours digits to flash.
Hours
3. Keep pressing (C) until the setting you
want to change is flashing.
●
Each press of (C) moves the flashing to
the next setting in the sequence shown
below.
Day
Month
Minutes
Hours
4. Use (D) to change the value.
●
Holding down (D) scrolls through
settings at high speed.
●
[-] is displayed for the month and [- -] is
displayed for the day if nothing is
specified for these settings.
●
While you are setting the timekeeping
hour, [P] (p.m.) is displayed during p.m.
times if you are using 12-hour
timekeeping, while [24] is displayed if
you are using 24-hour timekeeping.
5. Repeat steps 3 and 4 to select time and
date settings.
6. Press (A) to complete the setting
operation.
Note
●
While the setting is being configured,
the watch will exit the setting operation
automatically after about two or three
minutes of non-operation.
Watch Operation Guide 3529
7
Loading ...
Loading ...
Loading ...