Loading ...
Loading ...
Loading ...
Navigating Between Modes
Press (C) to cycle between modes.
●
After performing operations in any mode,
press (C) to return to the Timekeeping
Mode.
C
C
C
C
Alarm ModeStopwatch Mode
Timekeeping Mode
Timer Mode
Viewing the Face in the Dark
The watch has a light that illuminates the face
for viewing in the dark.
●
Turning On Display Illumination
Press (L) to turn on illumination.
●
Illumination will turn off automatically if an
alarm starts to sound.
Important!
●
Frequent use of illumination will run
down the battery.
Note
●
Display illumination is disabled when
any one of the conditions below exists.
ー
Alarm, timer alert, or other beeper
sounding
Time Adjustment
Use the procedures in this section to adjust the
date and time settings.
Adjusting the Current Time
Setting
Use the procedures in this section to adjust the
date and time settings.
●
Setting the Time/Date
1. Enter the Timekeeping Mode.
l
Navigating Between Modes
2. Press (A).
This causes the seconds to flash.
Seconds
3. Keep pressing (C) until the setting you
want to change is flashing.
●
Each press of (C) moves the flashing to
the next setting in the sequence shown
below.
Day
Month
Ye a r
Minutes
Hours
Seconds
4. Configure the date and time settings.
●
While the seconds are flashing,
pressing (D) will reset them to 00. 1 is
added to the minutes when the current
seconds count is between 30 and 59
seconds.
●
For all the other values, use (D) to
change the flashing setting.
Holding down (D) scrolls through
settings at high speed.
5. Repeat steps 3 and 4 to select time and
date settings.
6. Press (A) to complete the setting
operation.
Note
●
While the setting is being configured,
the watch will exit the setting operation
automatically after about two or three
minutes of non-operation.
Watch Operation Guide 3529
6
Loading ...
Loading ...
Loading ...