Loading ...
Loading ...
Loading ...
(8)
Electric Shock Hazard: To prevent electrical shock, disconnect power before
servicing unit. Use only a properly grounded and polarized electric outlet.
Regularly inspect the unit for any signs
of leakage. If there are signs of water
damage, immediately remove the unit
from service.
To avoid water damage from leakage,
replace all cut, loose or split tubing. .
A drain pan, plumbed to an appropriate
drain or outfitted with a leak detector (not
included) should be used in those applications
where any leakage could cause property damage.
PROPERTY DAMAGE
Only use mild cleaners to clean the
faucet and plastic components.
Cleaners with acids, abrasives,
alkaline or organic solvents will
result in deterioration of the plastic
components and void the warranty.
CLEANING THE FAUCET AND TANK
Scalding Hazard: Do not allow
water to boil. May result in
severe burns.
Factory temperature pre-set
is
190°F (88°C) ±5°.
the indicator two notches
to the right of vertical.
Adjust the thermostat
slowly, turning the dial
clockwise to increase temperature
or counter clockwise to decrease
temperature, then activate faucet
handle for 20 seconds to bring in fresh
water to be heated at the new setting.
Allow 5-7 minutes for water to reach
new temperature.
ADJUSTING THE THERMOSTAT
To reset the
+
-
thermostat to that setting, turn
For fresher tasting water,
add filtration to your
instant hot water
dispenser system. For
more information, call
1-888-856-6322.
RED AND GREEN LIGHTS
The Green light indicates
Hot Water is available.
The Red Light indicates
water is heating to
maximum adjustment.
approx. 194°
MIN
MAX
CARE AND USE
Loading ...
Loading ...
Loading ...