Loading ...
Loading ...
Loading ...
www.factorybuysdirect.com
200247-01A4
WARNING: Any change to
this log set or its controls can
be dangerous.
WARNING: This appliance is
for installation only in a solid-
fuel burning masonry or factory-
built replace, constructed of
noncombustible material, and
connected to a working ue.
WARNING: Keep the appli-
ance area clear and free from
combustible materials, gasoline,
and other ammable vapors and
liquids.
1. This appliance, as supplied, is only for
use with the type of gas indicated on the
rating plate. This appliance is convertible
for use with propane/LP, using the manual
ON/OFF safety pilot valve kit.
2. If you smell gas:
• Shut off gas supply
• Do not try to light any appliance
• Do not touch any electrical switches; do
not use any phone in your building
• Immediately call your gas supplier from
a neighbor's phone. Follow the gas sup-
plier's instructions
• If you cannot reach your gas supplier,
call the re department
3. Never install the log set:
• In a recreational vehicle
• Where curtains, furniture, clothing, or
other ammable objects are less than
42" from the front, top, or sides of the
log set
• In high trafc areas
• In windy or drafty areas
4. Before installing in a solid fuel burning
replace, the chimney ue and re-box
must be cleaned of soot, creosote, ashes
and loose paint by a qualied chimney
cleaner. Creosote will ignite if highly
heated. Inspect chimney ue for damage.
SAFETY
5. You must operate this log set with a re-
place screen in place. Make sure replace
screen is closed before running log set. If
the replace has glass doors, they must
remain OPEN while this log set is in op-
eration.
6. Do not allow fans to blow directly into the
replace. Avoid any drafts that alter burner
ame patterns. Ceiling fans can create
drafts that alter burner ame patterns.
Altered burner patterns can increase
sooting.
7. Do not use a blower insert, heat exchang-
er insert, or other accessory not approved
for use with this log set.
8. This log set needs fresh, outside air
ventilation to run properly. See the Air for
Combustion and Ventilation, page 6.
9. Do not run log set
• where gasoline, ammable liquids and
vapors are used or stored
• under dusty conditions
10. Do not burn solid fuel in the replace after
installing the log set. Do not use this log
set to cook food or burn paper or other
objects.
11. Log set becomes very hot when in use.
Keep children and adults away from hot
surface to avoid burns or clothing ignition.
Log set will remain hot for a short time
after shut-down. Allow surface to cool
before touching.
12. Carefully supervise young children when
they are in the room with log set.
13. Do not use appliance if any part has been
exposed to or under water. Immediately
call a qualied service technician to in-
spect the room appliance and to replace
any part of the control system (if using
control system) and any gas control which
has been under water.
14. To help prevent breakage, new logs must
go through the curing process (see Curing
Logs, page 13).
15. Turn log set off and let cool before servic-
ing, installing, or repairing. Only a qualied
service person should install, service, or
repair log set.
Loading ...
Loading ...
Loading ...