Sealey SDL11 Rechargeable Soldering Iron Kit 30W

Product's Documents

Below are documents related to this product, you can read online or download:
User Manual Other Documents
SDL11 photo

User Manual

This is the main product document for model SDL11.

The file format is pdf, 2 pages, you can download this manual here .

background
LITHIUM-ION RECHARGEABLE SOLDERING
IRON KIT 30W
MODEL NO: SDL11
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY
WARNING! Ensure Health & Safety, local authority, and general workshop practice regulations are adhered to when using this
equipment,makesureyouknowwherethenearestreextinguisheris.
WARNING!Alwayswearapprovedeye/faceprotectionwhenoperatingthesolderingiron.
WARNING!Donotusethesolderingironifyounoticedamagetotheworkpiece.
WARNING!Alwayspointthesolderingironawayfromtheeyesandbodywhenduringoperation.
WARNING!Donotputthesolderingirondown,putitbackinitsholder.
WARNING!Onlyuseinawellventilatedarea.
9 Keepammablematerialawayfromthetorchwhenoperating.
8 DO NOToperatethesolderingironwhenyouaretiredorundertheinuenceofalcohol,drugsorintoxicatingmedication.
8 DO NOTusethesolderingironinanareawherepaintfumes,solventsorotherammablesolids,liquidsorgasesposeapotential
hazard.
8 DO NOTholdanyworkpiecebyhand.
8 DO NOTtouchtheworkpiececlosetotheheatedareaasitwillbeveryhot.Allowtocool.
8 DO NOToperatethesolderingironifitisdamagedasthismaycausefailureand/orpossiblepersonalinjury.
8 DO NOTtouchthetopofthesolderingironduringorimmediatelyafteruse,asitwillbeveryhot.Allowtocool.
8 DO NOTallowchildrentooperatethesolderingiron.
9 Whennotinuse,storeawayfromdirectsunlightinasafe,dry,childprooflocation.
8 DO NOTstoreatover40°C,suchasinacarinhotweather.
2. INTRODUCTION
Cordlessandlightweightsolderingiron.InbuiltLEDtoilluminatesolderingareainlowlightareassuchasenginebays.Kitincludes
standard,chiselandheatshrinktipsaswellascleaningsponge,solder,standandUSBcharginglead.Heatsuptoamaximum
temperatureof600°Candhasa40minuteworkingtime.
3. SPECIFICATION
Model No.:.................................................................. SDL11
Battery:...................................................... 2.4AhLithium-ion
Charging time:................................................................3.5hr
MaximumTemperature:............................................... 600
0
C
OperatingTime:........................................................... 40min
Power Rating:.................................................................30W
Consumables:Seeg.1andtablebelow.
SDL11Issue2(3)26/08/22
Original Language Version
© Jack Sealey Limited
Refer to
instructions
Warning:
Hot surfaces
Do not cover
Wear eye
protection
Item Description Part number
1 SolderingwireforSDL11 SDL11.SW
2 ChargingcordforSDL11 SDL11.CC
3 SolderingstandforSDL11 SDL11.S
4 30W Chisel tip SDL11.CHT
5 Cleaning sponge SDL11.CS
6 30W Cone tip SDL11.CT
7 30W Lighter and heat shrink tip SDL11.LHT
8 Interchangeabletips(setof3)NOTSHOWN SDL11.T
9 TransparentcapforSDL11NOTSHOWN SDL11TC
g.1
Indooruse
only
background
4. OPERATION
4.1. CHANGING SOLDERING TIP
4.1.1. Ensure that the soldering iron tip is cold, select the appropriate tip and remove the current tip by applying a quarter turn to the tip
collar.Mounttherequiredtipbyliningupthelugs,slidingthecollardownthetoolandapplyingaquarterturn.
4.2. CHARGING
4.2.1. WhenconnectedtoaUSBpowersupplytheLEDinthehandlewillshowredwhilechargingandwillturngreenwhenfullycharged.
4.3. USING THE SOLDERING IRON
4.3.1. SlidetheHeatingandLEDcontrolslider(g.2)forwardtopreparethetoolforsoldering.
4.3.2. DepresstheredbuttonontopoftheslidecontroltoheatthetipandtoturnontheLED.Whiletheredbuttonisdepressedthetip
willcontinuetoheat.Ifthebuttonisreleasedthepowerise󰀨ectivelyswitchedo󰀨.
4.3.3. WhentheworkisdoneensurethattheHeatingandLEDcontrolsliderisreturnedtotheO󰀨position(g.2)andthatthetipiscold
beforestoringtheironbackinit’sbox.
5. MAINTENANCE
5.1. Ifsoiled,cleanthetoolusingusingaclean,dampcloth.DO NOTgetthetoolwet.
Original Language Version
© Jack Sealey Limited
Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR
01284 757500 01284 703534 sales@sealey.co.uk www.sealey.co.uk
ENVIRONMENT PROTECTION
Recycleunwantedmaterialsinsteadofdisposingofthemaswaste.Alltools,accessoriesandpackagingshouldbesorted,takento
arecyclingcentreanddisposedofinamannerwhichiscompatiblewiththeenvironment.Whentheproductbecomescompletely
unserviceableandrequiresdisposal,drainanyfluids(ifapplicable)intoapprovedcontainersanddisposeoftheproductandfluids
accordingtolocalregulations.
WEEE REGULATIONS
Dispose of this product at the end of its working life in compliance with the EU Directive on Waste Electrical and Electronic Equipment
(WEEE).Whentheproductisnolongerrequired,itmustbedisposedofinanenvironmentallyprotectiveway.Contactyourlocalsolid
wasteauthorityforrecyclinginformation.
BATTERY REMOVAL
Under the Waste Batteries and Accumulators Regulations 2009, Jack Sealey Ltd are required to inform potential purchasers of products
containingbatteries(asdefinedwithintheseregulations),thattheyareregisteredwithValpak’sregisteredcompliancescheme.Jack
SealeyLtd’sBatteriesProducerRegistrationNumber(BPRN)isBPRN00705.
Partssupportisavailableforthisproduct.Pleaseemailsales@sealey.co.ukortelephone01284757500
g.2
Note:Itisourpolicytocontinuallyimproveproductsandassuchwereservetherighttoalterdata,specificationsandcomponentparts
withoutpriornotice.
Important:NoLiabilityisacceptedforincorrectuseofthisproduct.
Warranty:Guaranteeis12monthsfrompurchasedate,proofofwhichisrequiredforanyclaim.
REGISTER YOUR
PURCHASE HERE
SDL11Issue2(3)26/08/22

Specifications

Indexed Terms: Soldering Iron

Sealey SDL11 Questions and Answers