Loading ...
Loading ...
Loading ...
Link speed setting
NOTE: Incorrect changes to the link speed setting might prevent the product from communicating with
other network devices. For most situations, the product should be left in automatic mode. Changes can
cause the product to power cycle. Changes should be made only while the product is idle.
1. On the control panel, press OK.
2. Use the arrow buttons to select Network config., and then press OK.
3. Use the arrow buttons to select CFG LINK, and then press OK.
4. Use the arrow buttons to select LINK, and then press OK.
5. Use the arrow buttons to select one of the following settings.
●
AUTO
●
10T HALF
●
10T FULL
●
100TX HALF
●
100TX FULL
●
100TX AUTO
●
1000TX FULL
NOTE: The setting must match with the network product to which you are connecting (a network
hub, switch, gateway, router, or computer).
ENWW Network configuration 41
Loading ...
Loading ...
Loading ...