Loading ...
Loading ...
Loading ...
25
P/N YRM276/YRM476-INST-FUL Rev C
Resetting Lock to Factory Default
WARNING: Enabling this feature could cause lock to be unable to lock electronically in
the event of a Door Position Sensor failure.
WARNING: Enabling this feature could allow someone to tamper with your lockset Door
Position Sensor preventing lock from being locked electronically.
To Enable:
1. Touch screen with back of hand or palm to activate.
2. Enter PIN code followed by key.
3. Select menu option 3 “Advanced Lock Settings” followed by key.
4. Select option 8 “Door Position Sensor” followed by key.
5. To enable the Door Position Sensor select option 1 “Enable Door Position Sensor”
key then key to complete setup.
During installation the Door Position Sensor functionality
is automatically disabled.
When resetting the lock, all user codes, including the
Master PIN code*, are deleted. All programming features
are reset to the original default settings (see below).
1. Remove the battery cover and batteries.
2. Remove the interior lock to access the reset button.
3. The reset button (see image at right) is located above the
PCB cable connectors.
4. Re-insert 3 batteries and hold the reset button for 3 seconds.
5. While still holding the reset button, insert the 4th battery,
and hold the reset button for an additional 3 seconds.
6. Release the reset button.
7. Re-install the interior lock onto the door.
Upon reset, Master PIN Code creation is the
only option available and must be performed
prior to any other programming of the lock.
For best results, the lock should be installed on the door when resetting the lock to factory default.
If the process was done and the lock was not installed on the door, review the Re-Handing instructions
listed in Hardware Troubleshooting.
*The Master PIN code must be registered prior to any other programming of the lock.
Interior Lock
followed by
Enabling Door Position Sensor Functionality
Loading ...
Loading ...
Loading ...