Loading ...
Loading ...
Loading ...
Part 1 – Introduction
10
I/O Connector
Audio
Out Audio Out
GND Grounding
In Audio In
Alarm
Out
Alarm Out (Active Low - Open
Collector Output)
GND Grounding
In Alarm In
• Wall/Ceiling Installation Hole
Used to screw the camera in place on a wall or a
ceiling.
• Cable Rubber
Foreign matter may get inside if reconnecting is
failed after removing the cable access hole rubber.
Factory Reset
Only use the factory reset button to restore the camera
to its factory default settings.
A factory reset will clear all camera settings congured
by the user.
1
Shut o the power supply.
2
Remove the dome cover.
3
Press and hold the reset button down
4
Hold the button down and apply the power.
5
Once the device turns back on, wait 5 seconds and
then release the reset button.
6
The device will go through the resetting process and
reboot. All camera settings will be restored to their
factory defaults after the reboot.
It's also possible to do a factory reset by pressing and
releasing the reset button while the camera is turned
on or using the IDIS Discovery program from a remote
location. A factory reset will reboot the system. For more
information on factory reset, refer to the IDIS Discovery
operation manual.
Loading ...
Loading ...
Loading ...