Loading ...
Loading ...
Loading ...
Frequently asked questions
100
Unusual behavior of the dishwasher
Problem Possible cause and solution
Program finished has ap-
peared on the display and
you cannot select or start
a program.
This is not a fault.
Open and close the door.
The dishwasher must remain switched on while you do
this.
The dishwasher fails to re-
act when buttons are
pressed. The display and
indicator lights remain
dark.
The dishwasher has turned itself off after the set Switch-off
time to save energy.
Press the button to turn the dishwasher on again.
The following fault mes-
sage is appears in the dis-
play:
Salt container lid not closed
correctly
The salt reservoir cover is not properly closed.
Close the salt reservoir cover.
The dispenser cover can-
not be closed.
Detergent residue is blocking the latch.
Remove the detergent residue.
The inside of the door and/
or the interior walls are
wet after a program has
finished.
This is not a fault.
It is caused by the drying system.
The moisture will dissipate after a short while.
There is still water in the
wash cabinet at the end of
the program.
(This does not apply to the
“Rapid” program.)
Before remedying the fault:
Turn the dishwasher off using the button.
The filter combination in the wash cabinet is clogged.
Clean the filter combination (see “Cleaning and care”).
The drain pump or non-return valve is blocked.
Clean the drain pump or the non-return valve (see
“Frequently asked questions”).
The drain hose is kinked.
Remove the kink.
The on-site drain trap is clogged.
Check and clean the drain trap.
Peak load cut-out
This is not a fault!
Your energy management system has detected a peak-
load in the energy supply. Some components in the
dishwasher stop operating for the duration of the peak-
load cut-out.
Loading ...
Loading ...
Loading ...