Loading ...
Loading ...
Loading ...
Operation
5
15
Starting and Stopping the Engine
Refer to the Engine Operator’s Manual packed with your snow
thrower for instructions on starting and stopping the engine.
To Engage Track Drive
1. With the throttle control in the Fast (rabbit) position, move
shift lever into one of the six forward (F) positions or two
reverse (R) positions. Select a speed appropriate for the
snow conditions and a pace you’re comfortable with.
2. Squeeze the drive control lever against the handle the
snow thrower will move. Release it and drive motion will
stop.
To Engage Augers
To engage the augers and start throwing snow, squeeze the
auger control lever against the left handle. Release to stop the
augers.
To Steer
With the drive control lever engaged, squeeze the right steering
trigger control to turn right. Squeeze the left steering trigger
control to turn left.
Heated Grips
CAUTION: It is recommended that you wear
gloves when using the heated grip. If the heated
grip becomes too hot, turn it off.
To activate the heated grips, move the switch found on the rear
of the dash panel into the ON position. See Figure 5-1.
Figure 5-1
Replacing Shear Pins
The augers are secured to the spiral shaft with shear pins (a) and
bow-tie cotter pins (b). If the auger should strike a foreign object
or ice jam, the snow thrower is designed so that the pins may
shear. If the augers will not turn, check to see if the pins have
sheared. See Figure 5-2.
(a)
(b)
Figure 5-2
CAUTION: NEVER replace the auger shear pins
with anything other than OEM Part No. 738-04124A
replacement shear pins. Any damage to the auger
gearbox or other components as a result of failing to
do so will NOT be covered by your snow thrower’s
warranty.
WARNING! Always turn off the snow thrower’s
engine and remove the safety key prior to replacing
shear pins.
Loading ...
Loading ...
Loading ...