Hikvision DS-K1T670MFWX Quick Start Guide User Manual

Loading ...

Note

The duress code and the super code should be dierent.

Elevator Control

Steps

Click Conguraon → Access Control → Elevator Control Parameters .

Enable Elevator Control.

Set the elevator parameters.

Main Elevator Controller Model

Select an elevator No. for conguraon.

Interface Type

Select a communicaon type from the drop-down list for elevator communicaon.

If you select RS-485, make sure you have connected the device to the elevator controller with

RS-485 wire.

If you select Network Interface, enter the elevator controller's IP address, port No., user

name, and password for communicaon.

Negave Floor Capacity

Set the negave oor number.

Note

●

Up to 4 elevator controllers can be connected to 1 device.

●

Up to 10 negave oors can be added.

●

Make sure the interface types of elevator controllers, which are connected to the same

device, are consistent.

Set RS-485 Parameters

You can set the RS-485 parameters including the peripheral, address, baud rate, etc.

Click Conguraon → Access Control → RS-485 .

Check Enable, and set the parameters.

Peripheral Type

Select a peripheral from the drop-down list according the actual situaon. You can select from

Card Reader, Extension Module, or Access Controller.

Note

Aer the peripheral is changed and saved, the device will reboot automacally.

DS-K1T670 Series Face Recognion Termianl User Manual

Loading ...

Hikvision DS-K1T670MFWX Face Recognition Terminal