Loading ...
Loading ...
Loading ...
1.
Click Event Management → Event Card Linkage .
2.
Select the access control device from the list on the le.
3.
Click Add buon to add a new linkage.
4.
Select the event source as Event Linkage.
5.
select the alarm type and detailed alarm to set the linkage.
6.
In the Linkage Target panel, set the property switch to on to enable this acon.
Host Buzzer
The audible warning of access control device will be triggered.
Capture
The real-me capture will be triggered.
Recording
The recording will be triggered.
Note
The device should support recording.
Card Reader Buzzer
The audible warning of card reader will be triggered.
Alarm Output
The alarm output will be triggered for nocaon.
Zone
Arm or disarm the zone.
Note
The device should support zone funcon.
Access Control Point
The door status of open, close, remain open, and remain close will be triggered.
Note
●
The door status of open, close, remain open, and remain close cannot be triggered at the
same me.
●
The target door and the source door cannot be the same one.
Audio Play
The audio prompt will be triggered. And the select audio index related audio content will be
played according to the congured play mode.
7.
Click Save.
8.
Oponal: Aer adding the device linkage, you can do one or more of the following:
Access Controller User Manual
95
Loading ...
Loading ...
Loading ...