Loading ...
Loading ...
Loading ...
7
Clip Plate
Figure 2-16 Remove the Clip Plate
4. Install the mounting base to the ceiling with three
PA4 × 25 screws.
Figure 2-17 Install the Mounting Base to the Ceiling
Notes:
The supplied screw package contains self-tapping
screws, and expansion bolts.
For cement wall/ceiling, expansion bolts are
required to install the camera. For wooden
wall/ceiling, self-tapping screws are required.
5. Route the cables through the cable hole, or the side
opening.
6. Install the main body to the mounting base and
insert the clip plate.
Figure 2-18 Install the Camera
7. Tighten the screws with the screw driver.
8. Connect the cables.
9. Check whether the image on the monitor is gotten
from the optimum angle. If not, adjust the camera
according to the figure below to get an optimum
angle.
Pan Position
[0°to 360°]
Rotation Position
[0°to 360°]
Tilt Position
[0°to 75°]
Figure 2-19 3-axis Adjustment
1). Hold the camera body and rotate the enclosure
to adjust the pan position [0° to 360°].
2). Move the camera body up and down to adjust
the tilt position [0° to 75°].
Loading ...
Loading ...
Loading ...