Loading ...
Loading ...
Loading ...
21
3. Continue adjusting all of the leveling legs to raise the
refrigerator until the top is within at least 1" (2.54 cm)
of the top soffit.
NOTE: If an anti-tip board has been used, adjust the
leveling legs until the top of the refrigerator is within
1/4" (6.35 mm) of the bottom of the anti-tip board as
shown. Do not crush the compressor cover.
IMPORTANT: Adjust in small increments to keep from
damaging the cabinet trim and causing problems with
the door alignment or top grille fit. To avoid damage to
the cabinet or leveling legs, do not apply more than 50
inch-pounds (5.65 Nm) of torque to the leveling bolts. The
leveling legs can be extended to a maximum of 1¹⁄
4" (3.18
cm) below the rollers.
INSTALL OVERLAY SERIES CUSTOM
PANELS
IMPORTANT:
Install the custom handles prior to installing the
panels on the refrigerator. For more information on
KitchenAid custom handle selection, refer to the
KitchenAid Catalog, visit www. kitchenaid.com, or
call 1-800-442-9991. In Canada, visit
www.KitchenAid.ca, or call 1-800-807-6777.
Create custom door overlay panels according to the
specifications in the “Overlay Series Custom Panels”
section.
KitchenAid is not responsible for the removal or
addition of molding or decorative panels that would
not allow access to the refrigerator for service.
DOOR PANEL INSTALLATION
1. Remove all tape and door bracing from the
refrigerator and freezer doors.
2. Open the refrigerator and freezer compartment
doors.
3. Remove the handle-side and top trims.
4. Slide the custom panels into the bottom and hinge
side trims on the refrigerator compartment and
freezer compartment doors, making sure that the
backer panel fits into the hinge side trims.
5. Reinstall the handle-side and top trims.
6. Remove the skin from the screw covers. Slide or snap
the screw covers into the handle trim section.
7. Check refrigerator level and alignment. Adjust if
needed.
AB
C
D
A. Center board 1/4" (6.35 mm) max. above refrigerator
B. Two 2" x 4" x 32" (5 cm x 10 cm x 81 cm) boards
C. Attach to studs with six #8 x 3" (7.6 cm) screws
D. Compressor cover
A. Trims
WARNING
Excessive Weight Hazard
Use two or more people to move and install panels.
Failure to do so can result in back or other injury.
A. Panels
1/4"(6 mm)
max.
2" (5 cm)
Loading ...
Loading ...
Loading ...