Loading ...
Loading ...
Loading ...
17
NOTE: Pass the dolly strap under the handles.
2. Place pieces of the shipping carton on the floor when
rolling the dolly and refrigerator into the house. Move
the refrigerator close to the built-in opening.
3. Place top of cardboard carton or plywood under
refrigerator.
4. Stand the refrigerator up. First, place the left bottom
edge of the refrigerator on the floor, stand the
refrigerator upright and then lower the right-hand
side of the refrigerator to the floor.
5. Reassemble the trim and top grille after the dolly has
been removed from the refrigerator.
INSTALL ANTI-TIP BOARDS
IMPORTANT:
To avoid tipping during use, the solid soffit must be
within 1" (2.5 cm) maximum above the refrigerator. If
the solid soffit is higher than 1" (2.5 cm) or one is not
available, then the refrigerator must be braced.
It is recommended that board(s) be installed before
the refrigerator is installed.
Board(s) must be long enough to fully cover the
width of the compressor cover.
Locate the board(s) so the bottom surface(s) of the
board(s) is (are) 84" (213 cm) from the floor.
During installation, raise the refrigerator up so there
is 1/4" (6.35 mm) maximum between the top of the
refrigerator and the bottom of the anti-tip board(s).
Do not crush the compressor cover when raising the
rear leveling legs.
NOTE: The foam gasket, on top of the compressor
cover, will compress to fit under the anti-tip board(s).
There is no need to trim the gasket.
TO INSTALL ANTI-TIP BOARDS
1. Mark the stud locations on rear wall.
2. Securely attach two 2" x 4" x 32" (5 cm x 10 cm x 81 cm)
boards to wall studs behind refrigerator. Use six
#8 x 3" (7.6 cm) (or longer) wood screws. The wood
screws must be screwed into the studs at least
1½" (3.8 cm). The boards must overlap the compressor
cover.
CONNECT THE WATER SUPPLY
Read all directions before you begin.
IMPORTANT:
If you turn the refrigerator on before the water line is
connected, turn the ice maker OFF.
Connect to potable water supply only.
Do not use with water that is microbiologically unsafe or
of unknown quality without adequate disinfection before
or after the system. Systems certified for cyst reduction
may be used on disinfected waters that may contain
filterable cysts.
CONNECT TO WATER LINE
PARTS NEEDED
Minimum 7 ft (2.13 m) flexible, codes-approved water
supply line
STYLE 1—SHUTOFF VALVE CONNECTION
NOTE: If your water line connection does not look like
Style 1, see “Style 2—Copper Line Connection.”
1. Unplug refrigerator or disconnect power supply.
IMPORTANT:
There is not enough clearance to achieve a flush
installation if a water shutoff valve is located in the
wall behind the refrigerator. The water shutoff should
be located in the base cabinet on either side of the
refrigerator.
2" (5 cm)
AB
C
D
A. Center board 1/4" (6.35 mm)
max. above refrigerator
B. Two 2" x 4" x 32" (5 cm x
10 cm x 81 cm) boards
C. Attach to studs with six
#8 x 3" (7.6 cm) screws
D. Compressor cover
2" (5 cm)
Loading ...
Loading ...
Loading ...