Loading ...
Loading ...
Loading ...
SOAP
Page 18
Ensure that the outboard soap injector is connected
to the washer high-pressure output.
1.
Soap hose
Attach high-pressure
hose connector here.
pump outlet
High-pressure
Soap injector
USING CHEMICALS (if equipped)
NOTICE
Pressure washing with volatile, ammable, or corrosive liquids could cause pressure
washer damage, re, or explosion resulting in severe injury and/or death. To avoid these
hazards, use only approved soaps and chemicals, do not attempt to pressure wash with
volatile, ammable, or corrosive liquids, and NEVER use bleach.
VOLATILE LIQUIDS
Place the ltered end of the soap hose into a
container of soap.
2.
Insert the black nozzle into the spray wand per
the Nozzle Installation section of this manual,
page 13. NOTE: Soaps will not siphon if the
black soap nozzle is not installed on the spray
wand.
4.
Make sure the trigger lock is in the locked position
before removing and installing nozzles.
3.
5.
After using soap, place the ltered end of the soap hose into a container of clean
water and run pressure washer drawing clean water through the hose and pump
until the system is thoroughly rinsed. If soap or other chemicals remain in the pump,
the pump could be damaged. Pump damage from soap or chemical residue is not
covered under warranty.
(Hose connector not shown)
Loading ...
Loading ...
Loading ...