Craftsman CMXGVAM1144036 208-cc 14-in Rear-tine Counter-rotating Tiller Carb

User Manual - Page 8

For CMXGVAM1144036.

PDF File Manual, 40 pages, Read Online | Download pdf file

CMXGVAM1144036 photo
Loading ...
Loading ...
Loading ...
8
ASSEMBLY
Installing Emergency Stop Control (If Equipped)
1. Locate the emergency stop control wire on the right side of the unit behind
the engine.
2. Route the emergency stop control wire up the outside on the right side lower
handle support and right side handle support bracket. Secure the wire to the
handle and support with a cable tie, slightly above the support bracket. See
Figure 8.
Figure 8
3. Route the wire over the upper handle, then behind the handle panel,
securing it to the right side of the handlebar with the clutch cables at the
upper corner of the panel. See Figure 9.
Figure 9
4. Route the wire behind the panel to the left side handle, and secure it
just above the upper corner of the panel with a cable tie. (Keep the wire
positioned along the inside of the handle). See Figure 10.
Figure 10
5. Mount the emergency stop control ON/OFF switch onto the left side of the
handlebar with the #10-32 : 1.50 hex bolt and 10-32 flange lock nut. See 1 in
Figure 11.
1
2
Figure 11
6. Secure the wire near the bottom of the handlebar with a cable tie looped
through the hole beside the instruction label on the left handlebar. See 2 in
Figure 11.
NOTE: Do not allow the wire to cover the safety label attached to the handle.
Label must be fully visible and legible.
Loading ...
Loading ...
Loading ...