Loading ...
Loading ...
Loading ...
www.factorybuysdirect.com
21200245-01H
9. Turn control knob counterclockwise
to the ON position. The main burner
should light.
10. Make sure the heater screen is in place
before operating heater.
11. If heater will not operate, follow the instruc-
tions To Turn O Gas To Appliance, and
call your service technical or gas supplier.
CAUTION: Do not try to ad-
just heating levels by using the
equipment shuto valve.
WARNING: If input gas type
is NG, make sure NG pilot burner
ignites. If input gas type is Pro-
pane, make sure Propane pilot
burner ignites (see Figure 36,
page 26).
6. With control knob pressed in, push
down and release ignitor button. This
will light pilot. The pilot is attached
to the burner. If needed, keep press-
ing ignitor button until pilot lights.
Note: If pilot does not stay lit, refer to
Troubleshooting, pages 27 though 30.
Also contact a qualied service technician
or gas supplier for repairs. Until repairs
are made, light pilot with match. To light
pilot with match, see Manual Lighting
Procedure.
7. Keep control knob pressed in for 30 sec-
onds after lighting pilot. After 30 seconds,
release control knob.
Note: If pilot goes out, repeat steps 4
through 8. This heater has a safety inter-
lock system. Wait one (1) minute before
lighting pilot again.
8. Be sure the slide switch on the front of the
receiver is in the ON position.
OPERATION
Shutting Off Heater
Turn control knob clockwise to the
OFF position.
Shutting Off Burner Only
(pilot stays lit)
Turn control knob clockwise to the
PILOT position.
1. Remove screen by lifting and pulling
forward.
2. Follow steps 1 through 6 under Lighting
Instructions, page 20.
3. With control knob in PILOT position, strike
match, and hold near pilot. Press in control
knob; pilot should light.
4. Keep control knob pressed in for 30 sec-
onds after lighting pilot. After 30 seconds,
release control knob.
5. Make sure the heater screen is in place
before operating heater.
TO TURN OFF GAS TO APPLIANCE
MANUAL LIGHTING PROCEDURE
THERMOSTAT CONTROL OPERATION
The thermostatic control used on this model
diers from standard thermostats. The ther-
mostat used on this heater senses the room
temperature AT THE REMOTE HANDSET. At
times the room may exceed the set tempera-
ture. If so, the burner will shut o. The burner
will cycle back on when room temperature
drops below the set temperature. The control
can be set to any temperature between 45°
F and 99°F.
Note: The location of the remote handset will
aect the operation. If it is in a warmer place
the unit will shut o before the room is warmed
Loading ...
Loading ...
Loading ...