Loading ...
Loading ...
Loading ...
English
11
Fig. T
34
MAINTENANCE
WARNING: To reduce the risk
of serious personal injury, turn appliance
off and remove battery before making any
adjustments or removing/installing attachments
oraccessories.
1. Keep the air intake slots
35
clean to avoid overheating
(Fig.U).
Fig. U
35
2. Your trimmer line can dry out over time. To keep
your line in top condition, store spare line in a plastic,
sealable bag with a tablespoon ofwater.
3. Plastic parts may be cleaned by using a mild soap and
a damprag.
4. The line cutter on the edge of the guard can dull over
time. It is recommended you periodically touch-up the
sharpness of the blade with afile.
Cleaning
WARNING: Blow dirt and dust out of all
air vents with clean, dry air at least once a week. To
minimize the risk of eye injury, always wear ANSI Z87.1
approved eye protection when performingthis.
WARNING: Never use solvents or other
harsh chemicals for cleaning the non-metallic parts
of the appliance. These chemicals may weaken the
plastic materials used in these parts. Use a cloth
dampened only with water and mild soap. Never let
any liquid get inside the appliance; never immerse any
part of the appliance into aliquid.
Accessories
WARNING: Since accessories, other than
those offered by
DEWALT
have not been tested with
this product, use of such accessories with this tool
could be hazardous. To reduce the risk of injury, only
DEWALT
recommended accessories should be used
with thisproduct.
Recommended accessories for use with your tool are
available at extra cost from your local dealer or authorized
service center. If you need assistance in locating any
accessory, please contact
DEWALT
, call 1-800-4-
DEWALT
(1-800-433-9258).
Replacing Spool Assembly (Fig.A, V, W)
1. Rotate the spool housing
9
until the hole
30
in the
spindle plate aligns with notch
32
in the guard. Insert
a screwdriver through the notch and into the hole, to
prevent the spindle fromturning.
2. Unscrew and remove the spool housing by turning the
spool head
22
clockwise.
nOTE: Do not try to remove the spool housing by
turning the spool cap
38
.
Fig. V
38
22
32
30
31
3. Remove spindle plate
36
before installing a new
housing. Remove any dirt and grass from the motor
housing and spindleplate.
4. Install spindle plate
36
onto the spindle
31
, so the
double D shaped retaining nut
37
on the spindle sits
inside the base of the spindleplate.
5. Align the spindle plate hole and notch, insert a
screwdriver back into the hole and thread the new spool
housing counterclockwise. Securely tighten the new
spool housing onto the spindle
31
.
Fig. W
31
36
37
Loading ...
Loading ...
Loading ...